The Saronni Goodwood Super confirmed

1982 Colnago Super ‘Profil’ , Goodwood ‘82 World Champion Beppe Saronni bike.

(Photo author , at La Collezione private preview , 12/22)

A while back a bicycle enthusiast contacted me for Colnago information , stating he was writing an article , and wanted to link to my site (here). I refused, deciding it was plagiaristic and lazy.

Following one post which was written in 2020 and completely misleading, with false information, and seeing the writer choose to reference me , I sent confirmation of what Colnago stated the bike that won Goodwood is on their official Facebook page in 2021 .

The writer did not correct the misleading article once made aware, so it will now be addressed properly here.

“SARONNI’S 1982 WORLD CHAMPIONSHIP BIKE CONFIRMED “


Part of this confusion can be attributed to a sign that is attached to Saronni’s bike in the Colnago museum that says ‘SUPER – Acciaio’ which translates as ‘SUPER – Steel’. However, if you visit the Colnago website ‘Hall of Fame’ page, you will see Saronni’s 1982 World Championship bike with a caption saying he won this race on a Mexico. These two pieces of information are conflicting.

So I emailed Colnago with the question: Which bike was it, a Super (Profil) or Nuovo Mexico? I received a reply from Colnago’s Chief Press Officer advising that Saronni’s bike was a ‘New Mexico’, the website it correct, the placard in the museum was incorrect. So ‘case closed’ – you would expect.

However, I was recently contacted by a vintage bike enthusiast (refer comments section below) whom has written a long article discussing this same topic. The premise of his article contradicts the information presented on Colango’s website. The author states that he has confirmed with Mr. Alex Colnago and Mr. Saronni that the bike used to win these world championships was definitely a Super – that featured crimped tubes.

So, like you, I’m a bit puzzled as I would expect Colnago to be an authoritative source about their own cycling history?”

(Quote “Rouler” , author Cycling Obsession)

Well , the writer has no contact with the Colnago family , and never met Saronni to ask him .

Soon after , the official Colnago Goodwood info was posted …

https://m.facebook.com/story.php?story_fbid=pfbid02JKpnS5Co5hWCKD7Jg3BJppRKZjpu8RX5aqZuooxqVPf4b8BUxV2LXTWsJkG8tpRcl&id=368678269130

The author posts a renovation thread , the only one on the whole site , re. a 1st gen circa ‘83/84 Nuovo Mexico , again with misleading info…

“The Nuovo Mexico is widely associated with Giuseppe (Beppe) Saronni and his successful Del Tongo team who raced on Colnago bikes. The Nuovo Mexico was no doubt instrumental in some of his victories which include the 1983 Giro d’Italia and Milan-San Rem”

As the above Colnago social media post states , Sarroni won the 83 Giro on a Super Profil.

Regarding “contradicts information”, one can find more misinformation on the authors site , eg, the C40 .

The first edition C40 had completely round tubes. As seen on one of the examples I owned….

https://www.flickr.com/gp/58441410@N04/D90M812jUo

Here in the writers article, he completely dismisses this as the first version C40 , simply because he hasn’t seen one ‘in the flesh’, or the correct catalogue …

“Colnago C40 Prototype (pre-1994)

When researching the C40 on the internet, there is mention of an earlier carbon lugged frame with round carbon tubes rather than the Master profile tubes usually found on the C40. However, I decided to only include C40 frames in this article that were listed in the Colnago catalogs and were therefore widely available to the general public.”

Quite arrogant to try and re write the history of one of the most iconic carbon racebikes .

Because of the authors lack of grasp of truth, one has to question his whole site . Titled as this…

“COLNAGO C40 – THE ULTIMATE GUIDE”

It clearly is not , it’s just an opinion of the C40 .

Colnago Master Olympic

My first Colnago Master,

A ’94 Olympic

This had a mixed up group when I got it, lower end Campagnolo gearing, Shimano drive.

I stripped it, and discovered the driveside dropout and derailleur hanger was bent.

I found a good bike shop who managed the straighten it, then I customized.

Chorus 10 speed ergo group, and the stem and bars were a lucky find.

When you’re on this on a sunny day, it’s a head-turner.

I finally managed to find the right forks

Head office has resurrected the red decor scheme for the Colnago Master 30th Anniversary

http://www.colnago.com/master/.

Shock of Shocks!

the chain seized up the rear derailleur

and sheared off it’s hanger

I annihilated myself with 6 cans of beer to get over the shock and heartache .

Those wiser than I in the way of the Velo ( Velo – Tao ?) told me

I should be able to get the hanger TIG welded back with minimal cosmetic damage,

and that the problem has happend to a million road bikes.

But why mine?

Arrrgghhhhhhhhhhhhhhhhhhhhhhhhhhhhhhh!

Progress reports will follow….
well, what do you do when your heart is broken?

Get a new one!

About a week later I managed  to get my hands 0n a ’96

Olympic same size, same decor!

8150370905_61b4d3ea8e_z

8150370765_c2c995f634_z

001
Jah will provide!

jah med

(http://goldensaddlecyclery.bigcartel.com/product/ride-jah-bike)

The ’96 had one owner from new, and had been in his garage the last few years,

my old ’94 model is on the left, the’96 has bigger tubing, and the recesses in the crimped areas are less concave.

002

It came with Shimano 600 Tricolor, and Ultegra shifters.

I found a used Campagnolo Chorus 10 speed rear mech to replace the damaged one,

and will donate everything from the ’94 on to it.

I wasn’t happy with the wear on the brake surface of the black Campagnolo Omega rims,

so I contacted Nigel at Campoldy.co.uk and got some silver Omega V rims.

Nigel is an absolute Gent and enthusiast , with extensive experience and is willing to help,

here’s a link

http://www.campyoldy.co.uk/

I got the ’94 back

TIG welded, and I’m happy with the finish as it caused a minimum of cosmetic damage to the frame,

sold, and shipped to Japan!

On the ‘new’ Master, I wanted to change the shifters,as the current set has some cosmetic wear and tear marks,

but none yet, those I have seen in good condition have been overpriced.

Shot of the ’96,

001

I’ll say it again,an unbelievably fortunate find, same colour scheme as my old one, but in pretty much pristine condition.

I just have to build the wheels now.

I managed to get some nos Campagnolo 10 speed shifters at the 11th hour, just before completion

001

002

Finished!

001

002

003

005

004

006

008

009

007

I changed the tyres to some gum walls…

010

017